DUKE FIRMWARE UPDATE

1. Download the firmware that correspond to your controller: Cortana | Black | White
2. Open the extracted software.
3. Hold down the left analog stick (L3) while plugging in the controller to your PC, continue holding
   until the software says “ONLINE”.
4. Once online, release the left analog stick and download the firmware.
5. Unplug the controller.
6. Hold down the 3 middle buttons under the screen (Share, Pause, Menu) and plug the controller in,
   wait until the animation on the screen finishes and ends on the Xbox logo.
7. Release the 3 buttons.
8. Press A.
9. Press A again.
10. Unplug the controller.
11. Plug it back in.
12. Test the controller on the following website: https://gamepad-tester.com/

After doing the following, the dead zone on the trigger should be fairly low.

 

** No software is needed for this, but it will need to be plugged into a PC.

 

1. Plug in the controller while holding down the 3 middle buttons under the screen (Share, Pause, Menu)
   and plug the controller in, wait until the animation on the screen finishes and ends on the Xbox logo.
2. Press A. (IMPORTANT: DO EACH STICK ONE AT A TIME).
3. Rotate the left stick in a circle, followed by the right stick (IMPORTANT: DO EACH STICK ONE AT A TIME)
4. Press in the left trigger 3 times, followed by the right trigger.
5. Press A again.
6. Unplug the controller.
7. Replug the controller and check on https://gamepad-tester.com/